No products were found matching your selection.
Other Related Products
-


DR20\40\50\20T\40T Soften valve series is floating bed, all appearance and geometric parameters and parts is the same as the corresponding GR20\40\50\20T\40T, floating bed has a good water quality, to adapt high hardness of the raw water, configuration swap tank should be fine and high, runing velocity in the 30-60 m/h, but resin filling rate must be above 90%, being stable working pressure,The floating bed is not suitable for frequent starting and changing water consumption.
-


Incorporates 2 time-tested, hydraulically-balanced pistons to independently pilot service flow and regeneration
For use with single or multiple tank systems
Backwashes softener tanks up to 36″ diameter
Continuous flow rate of 106 GPM
-


Applicable to all kinds of small and medium-sized single-stage, double-stage reverse osmosis control system. With simple operation, complete measurement and configuration, highly integrated system
-


“One Dynamic and Two Static” Double Static Ceramics Plates Multi-port Valve is on behalf of another beginning in the field of water treatment control, which can overcome many disadvantages of traditional products in installation.
-


ZR type double tank floating bed control valve including ZR4-1/ZR4-1S(Side Loading), ZR10-1/ZR10-1S(Side Loading). It is equiped the inlet flow Meter and drainage flow meter, All the parameters is set by water volume, The double swap tank is for Alternating regeneration. Continuous water production, Water quality is stable , Adapted to the to high hardness water softening, such as the steam boiler and heating engineering and production process water.
-


FLECK control valve 5600 softening water equipment generally uses fixed bed downstream
regeneration, the working process is operation, backwashing, regeneration, replacement,
positive washing, salt tank water injection.
-


GR20\40\50\20T\40T series up flow regeneration fixed bed large valve series, water production range is 15T/ h-70t /h, the inlet flow meter is used to set the cycle of water production, slow backwash water and wash water, and the brine flow meter and the brine electric valve are used to specifically measure brine absorption and salt tank water supply.In the flow mode, the internal flow transducer realizes the switch of all stations as long as the amount of brine,the amount of slow washing water and the amount of washing water is set according to the volume (liter) of the swap tank. After the period of softening water amount (ton) is set according to the hardness of the raw water, each station decreases to “0” according to the set value, and stops decreasing and maintains when the water is out of service or no water.
-


On-line analysis and process control of the oil refining, metallurgy,chemical synthesis industry process;
-


Fully adjustable, 5-cycle control delivers upflow backwash, downflow brining, slow rinse, rapid rinse, brine refill, and downflow service
Time-tested, hydraulically-balanced piston, seal and spacer, controls service flow and regeneration
Non-corrosive, fiber-reinforced polymer construction
Excellent flow rates (19 GPM continuous, 24 GPM peak)
Backwash capacity handles tanks up to 16″ diameter for softener, and filter