Step-by-Step Guide to Installing a Pentair Multiport Valve
Installing a Pentair multiport valve is a crucial step in maintaining your pool’s filtration system. This valve allows you to easily switch between different functions such as filtering, backwashing, rinsing, and more. In this step-by-step guide, we will walk you through the process of installing a Pentair multiport valve to ensure that your pool stays clean and clear all season long.
Before you begin the installation process, it is important to gather all the necessary tools and materials. You will need a screwdriver, pipe wrench, Teflon tape, PVC glue, and of course, the Pentair multiport valve itself. Make sure to read the manufacturer’s instructions carefully before starting the installation to ensure that you are following the correct steps.
The first step in installing the Pentair multiport valve is to shut off the power to the pool pump. This is crucial for your safety and to prevent any damage to the equipment. Once the power is off, you can begin by draining the water from the filter tank. This can be done by opening the drain plug at the bottom of the tank and allowing the water to flow out.
Next, you will need to remove the old valve from the filter tank. This can be done by loosening the clamp that holds the valve in place and carefully pulling it out. Make sure to inspect the O-ring on the old valve and replace it if necessary to prevent any leaks in the future.
Once the old valve has been removed, you can begin installing the new Pentair multiport valve. Start by applying Teflon tape to the threads of the valve to ensure a tight seal. Then, carefully insert the valve into the opening on the filter tank and secure it in place with the clamp provided.
After the valve is securely in place, you can begin connecting the pipes. Use a pipe wrench to tighten the connections and ensure that there are no leaks. Once the pipes are connected, you can apply PVC glue to the joints to create a watertight seal.
Once all the connections are secure, you can begin filling the filter tank with water. This can be done by opening the air relief valve on top of the tank and allowing water to flow in. Once the tank is full, you can turn the power back on to the pool pump and test the valve to ensure that it is functioning properly.
| Model: Automatic Softener Valve | ASE2 -LCD/LED | |
| Refilling type | refill before regeneration | refill after regeneration |
| Working Position | Service->Refill the softener water->Service->Back Wash->Upflow Brine and slow rinse->Fast rinse->Service | Service->Back Wash->Upflow Brine and slow rinse-> Fast rinse-> Refill the softener water->Service |
| Automatic type | Automatic type | |
| Meter Delay | Meter Delay | |
| Regeneration mode | Intelligent Meter Delay | Meter immediate |
| Timer by day : 0-99 days | Intelligent Meter Delay | |
| Timer by hours: 0-99 hours | Intelligent Meter Immediate | |
| Timer by day : 0-99 days | ||
| Timer by hours: 0-99 hours | ||
| Inlet | 1/2” 3/4” 1” | |
| Outlet | 1/2” 3/4” 1” | |
| Drain | 1/2” | |
| Base | 2-1/2” | |
| Riser pipe | 1.05” OD | |
| Water Capacity | 2m3/h | |
| Working Pressure | 0.15-0.6Mpa | |
| Working Temperature | 5-50°C | |
| Power Supply | AC100-240 / 50-60Hz / DC12V-1.5A | |
In conclusion, installing a Pentair multiport valve is a relatively simple process that can be completed in just a few hours. By following the steps outlined in this guide, you can ensure that your pool’s filtration system is working efficiently and effectively. Remember to always read the manufacturer’s instructions and take proper safety precautions when working with pool equipment. With a properly installed multiport valve, you can enjoy a clean and clear pool all season long.
