FLECK Control Valve 2510
Fully adjustable, 5-cycle control delivers upflow backwash, downflow brining, slow rinse, rapid rinse, brine refill, and downflow service
Time-tested, hydraulically-balanced piston, seal and spacer, controls service flow and regeneration
Non-corrosive, fiber-reinforced polymer construction
Excellent flow rates (19 GPM continuous, 24 GPM peak)
Backwash capacity handles tanks up to 16″ diameter for softener, and filter
Fleck 2510 Valve
1″ Residential control valve
Features:
(1)Fully adjustable, 5-cycle control delivers upflow backwash, downflow brining, slow rinse, rapid rinse, brine refill, and downflow service
(2)Time-tested, hydraulically-balanced piston, seal and spacer, controls service flow and regeneration
(3)Non-corrosive, fiber-reinforced polymer construction
(4)Excellent flow rates (19 GPM continuous, 24 GPM peak)
(5)Backwash capacity handles tanks up to 16″ diameter for softener, and filter
Applications:
(1)Corrosion-free bypass valve
(2)Mechanical control (7- or 12-day clock or metered initiated regeneration)
(3)Electronic control (time clock or metered initiated regeneration)
(4)Manual operation
(5)No hard water bypass
(6)Environmental cover
(7)Auxiliary switches
(8)Meter delayed or immediate initiated regeneration
(9)Filter or softener control valves
WATER PRESSURE: A minimum of 20 pounds of water pressure (1.3 bar) is required for regeneration valve to operate effectively.
ELECTRICAL FACILITIES: An uninterrupted alternating current (A/C) supply is required. Note: Other voltages are available. Please make sure your voltage supply is compatible with your unit before installation.
EXISTING PLUMBING: Condition of existing plumbing should be free from lime and iron buildup. Piping that is built up heavily with lime and/or iron should be replaced. If piping is clogged with iron, a separate iron fi lter unit should be installed ahead of the water softener.
LOCATION OF SOFTENER AND DRAIN: The softener should be located close to a drain to prevent air breaks and back fl ow.
BY-PASS VALVES: Always provide for the installation of a by-pass valve if unit is not equipped with one.
CAUTION: Water pressure is not to exceed 125 psi (8.6 bar), water temperature is not to exceed 110°F (43°C), and the unit cannot be subjected to freezing conditions.
